pb working speed wnc

[jigen]

Hello everyone
I have a problem with worknc v18.
processing : grinding htn
tool : diameter 6, torica 0,7
speed: 8000

pb : imposed working speed at 5000 and the postprocessor generates a file all in g00 !!! if instead imposed a lower working speed )type 2000-3000-4000) then uses, correctly, also g01, g02 etc.

?? ? ? ? ! ! ?

I think there is some parameter that defines a threshold for speeding up work: where is it?
What do I do?

 

[cennico]

Hi. you have to go into the postprocessor file.dat that you use and: in the speed voice beyond which to go quickly you have to place a value greater than 8000 in your case. I usually use 20000.
I hope I have been of help (maybe a little late).
Hi.

alessandro.