Frn
Guest
I have a problem with printing 3d objects (e.g. a pipe) obtained with the extrude command.
this happens: the nuance of these objects, which appears correctly at video, completely disappears in pdf printing.
I have unnecessarily tried with all the various print options.
But I must point out this: that a correct press became what is possible is evidenced by the fact that at least a couple of times I accidentally got correct prints, but without being able to repeat the same result while setting the same print parameters.
Can you tell me something?
this happens: the nuance of these objects, which appears correctly at video, completely disappears in pdf printing.
I have unnecessarily tried with all the various print options.
But I must point out this: that a correct press became what is possible is evidenced by the fact that at least a couple of times I accidentally got correct prints, but without being able to repeat the same result while setting the same print parameters.
Can you tell me something?