Devis
Guest
Good morning to all, does anyone have any suggestions to give me about these corners? on all sides of this sheet must be a fold!! Thank you.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
cacciatorino
Guest
1) solid edge or solidworks? What version? the attached file is solidworks... .Good morning to all, does anyone have any suggestions to give me about these corners? on all sides of this sheet must be a fold!! Thank you.
2) Put on a jpg first
3) the title of the post should synthetically recall the subject, but the word "pieghe" is perhaps too synthetic.
Devis
Guest
is in solidworks 2010
meccanicamg
Guest
Hello Devis,
I've seen this model here. http://www.cad3d.it/forum1/showthread.php?t=20290.
do not need to make double posts, get the opposite effect of what you want.
as you had been told before you have to make the flanges of the edge that lack and edit the sketch so as to get the correct joint of edge.
otherwise try another modeling approach. from full and empty or make it all flat and fold after with the fold lines.
I've seen this model here. http://www.cad3d.it/forum1/showthread.php?t=20290.
do not need to make double posts, get the opposite effect of what you want.
as you had been told before you have to make the flanges of the edge that lack and edit the sketch so as to get the correct joint of edge.
otherwise try another modeling approach. from full and empty or make it all flat and fold after with the fold lines.
Devis
Guest
I'm sorry you're right. It was a question I've already asked.