pillar joint wall

[Padella]

Hello everyone,
I have a problem with revit 2018 in shaping a structure with pillars.
as you can see in the attached images the walls overlap the pillars with their stratigraphy and lose their shape.
I tried to use structural pillars but I did not solve and more 'in architectural plants are not visible; I also tried the command to unwind element with dx key going then to manually extend the wall, but nothing...how can I solve this problem?? ?

 

[Tristan]

the architectural columns merge with the architectural walls; idem structural pillars with structural walls.
If you don't want them to be joined, you can always use the 'disjunct geometry' command, but you would have geometries overlap.
the best thing to do is to use architectural walls and structural pillars; join them and you will see that the wall will be drilled by the pillar

 

[Padella]

the architectural columns merge with the architectural walls; idem structural pillars with structural walls.
If you don't want them to be joined, you can always use the 'disjunct geometry' command, but you would have geometries overlap.
the best thing to do is to use architectural walls and structural pillars; join them and you will see that the wall will be drilled by the pillar

thanks for the undications...I tried but then in the architectural plants how do I x see the structural pillars??? At that point, can I just work on the structural ones by changing the quotas of the horizontal section planes x cutting the openings? ?

 

[Tristan]

if you do not see the structural pillars you will probably have the category turned off