massimo2015
Guest
hello to everyone, who of you can give me directions, how can I change the mastercam post processor mcx6,
To understand, I am turning a pantograph with ncx control, which wants the code g of interpolation to each block :-(
Can someone help me on how to intervene, until the post gives me blessed codes?
It would be good even if such work could also make it an external editor like cymco.
Thank you very much.
To understand, I am turning a pantograph with ncx control, which wants the code g of interpolation to each block :-(
Can someone help me on how to intervene, until the post gives me blessed codes?
It would be good even if such work could also make it an external editor like cymco.
Thank you very much.