powermill machining board

[luma80]

hi to everyone, I have to change my powermill processing card but when I go preview the changes on the table I see them
while the data powermill,diameter overmetal tool etc.. I don't get out.
Has anyone done anything like that?

 

[filippo b]

to change the powermill card, you need an html editor (frontpage, sharepoint, coffee, etc.), if in the edit you have disappeared data that you previously had means you have violated the syntax

 

[luma80]

What do you mean?

 

[filippo b]

What do you mean?
I'm sorry, I'm sure I got it wrong. In fact, I understood that you had to edit a powemill html card (the original of the installation?) and, after modification, you had disappeared data you had previously. the aforementioned supermetal, for example, has this syntax "{thickness}", if it disappears means, probably, that it was not respected.

 

[luma80]

the syntax remained the one before.
I just added a blank table,with this change I miss everything

 

[filippo b]

the information in this discussion is too few to help you.