pre-view feature

[sweeping]

Hello, everyone.
I remember that in wildfire 2 a hole (...for example) was pre-displayed in the modeling window when selecting it in the modeling shaft even when the model was not very zoomed.
in creo 2.0, instead, is pre-visualized only if the model is zoomed enough not to make the hole too small. It's pretty appetizing for me. Is there any configuration editor voice to set to make a feature selected in the modeling tree pre-displayed with any zoom level?
thank you in advance to anyone who can give me an answer.

ps: perhaps the correct section was that of the configuration. Sorry.

 

[tartufon80]

Bye!

I don't know, the variable I think is always the same: prehighlight_tree to set to yes.
And I imagine you already have this setting as you say.

I would think it depends on your video card, its settings or drivers, or the creo display settings, which are set in this way not to weigh too much on performance.

I don't know what level of zoom you're referring to, but I checked and I don't have this problem. Maybe try to control the video settings, between the crack options.

 

[sweeping]

on your suggestion I pulled out on some setting and it seems that I solved:
file -> options - > model display - > shading small surfaces (i.e. skip_small_surfaces -> no)
I thank you again for the concern to my question.
to the next

 

[tartufon80]

bene!! :finger:

buon lavoro!