precision type

[DANI-3D]

Say hi.

I have to admit that until recently I have not given the right importance to precision. Since, although rarely, the relative accuracy of default 0.0012 is not enough to represent good of small threaded holes on a large set of carpentry I am using a value of 0.0001 both for total and for details, with obvious delays in the regeneration phase.

Before starting to remedy I would like advice to use optimal values and clarifications on the difference between relative and absolute precision.

Thank you.

 

[Prof.]

I prefer to work with absolute precision of a centimeter. so both I make small models and big models I have no problem.
Bye.

 

[DANI-3D]

Okay.

But what's the difference between the two types of precision?

 

[Prof.]

relative precision changes proportionally with the size of the model, the absolute one does not.