presentation

[simoxxx3]

hello to all I am going to deliver a project of a boat and for the presentation I prepared the usual sheet to views.
I wondered if there was a way to get the view of the mechanical parts inside the boat while maintaining a silhouette of the snailed boat.

thank you very much to all:smile:
simone

 

[Catafratto]

I'll tell you what comes to my mind...
create two positions and two views. in the rapp. of view that you created hide the outside walls (so they call themselves in a boat? Now the navals are shitting me! I remember again when I said "corda"...) and the piazzi at the table with this active view; then make a superimposed view using the second rapp. of position (which is equal to the first but serves precisely to overlap it) with the complete boat. This way you see your entire boat covered. if you want you can, acting directly on the properties of the view (dx key on the axieme boat) change type and color of line. I hope I explained. . .

 

[simoxxx3]

Thank you so much!! I try as soon as I can because I have to finish by today and even the odds have problems, I can enlarge the arrows and the rest but the quota text does not vary! !

 

[simoxxx3]

I don't understand why!!
as disabled the hull also disables me in the views...

 

[Catafratto]

have you created the visual representations? in the one associated with the inside of the boat remove visibility outside, in the other leave everything as it is. then activate the visual representations at the table.

 

[MauroM]

I don't understand why!!
as disabled the hull also disables me in the views...

If I'm not wrong... in the sections the command overlay views does not work.