FlyHagoromo
Guest
Good evening to all,
I need help. I am carrying out the fem analysis of one of the two jaws of a "Swedish" model giratubi key and I am in doubt on which configurzaione to adopt for the definition of the constraints (allego file below). I would also like to apply a distributed load not on the whole upper face of the handle, but only on one side; I have always read on the forum that this can be done through the "cuci" command in the "generative shape design" environment but I just can't understand how. Unfortunately use catia recently so they are still inexperienced.
I trust in your help
Thank you.
I need help. I am carrying out the fem analysis of one of the two jaws of a "Swedish" model giratubi key and I am in doubt on which configurzaione to adopt for the definition of the constraints (allego file below). I would also like to apply a distributed load not on the whole upper face of the handle, but only on one side; I have always read on the forum that this can be done through the "cuci" command in the "generative shape design" environment but I just can't understand how. Unfortunately use catia recently so they are still inexperienced.
I trust in your help
Thank you.
