SolidUser
Guest
I had read a few days ago about the forum about the search form that gave few or almost no results.
I read again about these problems and today I came across too.
I searched for 'specking' on the forum of solidworks and did not give me any results.
I searched for '485684' and '485684' which are two juices reported by a user, it seems to me lelepanz, which bothered me too.
working with sw2011 seems to me resolved and I wanted to share this beautiful discovery, but I do not find the topic on which to continue to give info.
However I attach two files, one with written problem and clearly contains the problem (impossible to mirror the holes and a tooth on the undesired profiles) and the other done with 2011 where it is feasible without any workaround.
However I wanted to have confirmation, if possible, from those who reported the problem and why not, also from other volunteers.
I read again about these problems and today I came across too.
I searched for 'specking' on the forum of solidworks and did not give me any results.
I searched for '485684' and '485684' which are two juices reported by a user, it seems to me lelepanz, which bothered me too.
working with sw2011 seems to me resolved and I wanted to share this beautiful discovery, but I do not find the topic on which to continue to give info.
However I attach two files, one with written problem and clearly contains the problem (impossible to mirror the holes and a tooth on the undesired profiles) and the other done with 2011 where it is feasible without any workaround.
However I wanted to have confirmation, if possible, from those who reported the problem and why not, also from other volunteers.