problem print view trimmed

[Morgan Zen]

Hello, everyone!
I have a part where I created a sketch of a circumference that is displayed on the respective table.
When I create a trim view that cuts the circumference, I see the circumference cut correctly, while when I go to print solidworks adds a link line between the two trim points of the circumference.

Would someone know how to print this trimmed view without displaying this link line?
I attach screenshots.

Thank you.

 

[jenuary]

Have you tried to right-click on the line? even if I don't believe you let her select

 

[Morgan Zen]

Have you tried to right-click on the line? even if I don't believe you let her select

Unfortunately that line is only displayed in print preview, so on the table I can't select it.

 

[jenuary]

the assistance he says, have you tried to hear it?

 

[Morgan Zen]

the assistance he says, have you tried to hear it?

I heard my dealer's assistance, they will check and eventually open a signal directly to the solidworks, which they may be a bug.
Meanwhile I found a workaround: on the sketch of the part, cutting a small portion of the circle and then reuniting the two points of the circumference, the incriminated line is no longer displayed in print.

 

[jenuary]

I heard my dealer's assistance, they will check and eventually open a signal directly to the solidworks, which they may be a bug.
Meanwhile I found a workaround: on the sketch of the part, cutting a small portion of the circle and then reuniting the two points of the circumference, the incriminated line is no longer displayed in print.

You did well to report. well the fact that you found a loophole. Thank you for sharing