problem with curved repetition

[Ramon84]

Good morning to all,
I'm almost neophyte with solidworks and I really like to learn.
but I'm stuck with a problem about a repeat led by a curve.
I'll explain better.
I created an extrusion starting from a circular crown (a round tube practically) and at one of the two ends I applied an extruded cut to get a tilted face (as if the tube was cut not perpendicularly to your axis).
I then created on this face a "foot" of centering, which I would like to repeat on the tilted face created by the previous extruded cut.
Unfortunately, the result is not the one hoped for.
allego file "encrypted"
Can you please help me?
Thank you very much

 

[SimoneCRV]

mirrored like this?

 

[SperX]

I would repeat the sketch

 

[Ramon84]

mirrored like this?

Unfortunately I can't open the file because it is saved with a newer version.

 

[Ramon84]

I would repeat the sketchView attachment 64092View attachment 64094

Exactly!
would you be so kind to point out the steps to get to this solution starting from the sketch of the single pin?

 

[SperX]

delete the extrusion and change the sketch by adding the parts you need and then re-extrude.make the construction lines first with the corners. And then you draw the part that interests you.
I hope I've been clear. .

 

[MassiVonWeizen]

the repetition on the curve does not serve to do these things.
method 1:
draws the negative of a sector and then uses circular repetition in sketch environment
size by setting an offset from the surface
method 2 (to test);
draws the negative of a single sector
size with offsett from the surface
do ina circular repetition by flagging geometric repetition