problems with connection 3d

[jim78b]

I have to do with the cmando "fillet" a sheet that has a certain radius as in figure...autocad does it but go beyond I do not know if I explain, should limit itself only to the rectangle but the ray connection goes to the bottom of the sheet as I can remedy this? ? ?

 

[Alberto.E]

Hi.
you can handle the problem in several ways.
1. before applying the radius divide the sheet with the _slice command exactly where you want to finish the fillet, apply the radius and then reunite the pieces
2. apply the radius as you have already done, then cut the extra ray and rebuild it
3. try to create a small drain at the end of the fold (as it would be then in reality) and see if autocad no longer prolongs the fillet until the end of the sheet.

test... autocad is like this... to get to a result there are a thousand ways sometimes a little bit Moroccan.

 

[jim78b]

by unloading you mean right interruption? ? ?