quotation threads

[tecmec]

I press that I did a research and found nothing,
after drawing my par and creating the dft I go to quota the threads I have made, but I get out the quota with the sign of the diameter if then I go to change the quota inserting the prefix I get out a job like that
m6 sign of diameter (fi ) 6.
Where am I wrong?

 

[gerod]

means that on the height style you have the (phi) set for the diameters and then when quoting a diameter puts the simbolet.
to remove it you must remove the tick from the style or obscure the quota and put m6 by hand.

 

[radio]

when quoting a thread from "selecting tool -prefix" selects "throat size %ts", then from "selling tool - quota type" hides the value (x gray)

 

[Be_on_edge]

when quoting a thread from "selecting tool -prefix" selects "throat size %ts", then from "selling tool - quota type" hides the value (x gray)

I agree and add that handwriting the filet value is a practice to autocad and therefore not recommended, i.e. if a tomorrow changes the size of the thread, then remember to change the share. and think that there are those who think this is a good method!

Hi.

 

[tecmec]

when quoting a thread from "selecting tool -prefix" selects "throat size %ts", then from "selling tool - quota type" hides the value (x gray)

tried this was what I wanted thanks:smile: