MARCOC
Guest
Hi.
recovery quotas from the model in the idw...in the case of holes obviously the quota in the sketch of the model starts from the center... the problrema and that then on the table on the hole we go the axes and therefore the extensions of the lines of quota must start from the end of the axis and not from the hole... you can solve this problem.. ? ?
Thank you very much
recovery quotas from the model in the idw...in the case of holes obviously the quota in the sketch of the model starts from the center... the problrema and that then on the table on the hole we go the axes and therefore the extensions of the lines of quota must start from the end of the axis and not from the hole... you can solve this problem.. ? ?
Thank you very much