quote for work

[beny]

hello to all, I have recently passed from worknc to mastercamx6 and I have a small difficulty. I have to anticipate a job but I can't find in mastercam the possibility of being able to see or print the working time and length of the paths. Does anyone know how to give me directions? Thank you and good Sunday to all.

 

[beny]

hello to all, I have recently passed from worknc to mastercamx6 and I have a small difficulty. I have to anticipate a job but I can't find in mastercam the possibility of being able to see or print the working time and length of the paths. Does anyone know how to give me directions? Thank you and good Sunday to all.

Can't anyone help me?? Hi.

 

[kuman]

hi beny....in mastercam there is the option worksheet that gives you all information about the tool path. In any case, when you go check it out, if you click on the 2 blue arrows that appear in the window, expand it and click the information tab below and you have all the time. In my opinion the calculation approaches not so much for short operations and small pieces as for operations where the tool contact is greater.

 

[beny]

thank kuman I did not find the worksheet but how you addressed me in the info of the route there is everything. Good day

 

[Mike1967]

hello to all, I have recently passed from worknc to mastercamx6 and I have a small difficulty. I have to anticipate a job but I can't find in mastercam the possibility of being able to see or print the working time and length of the paths. Does anyone know how to give me directions? Thank you and good Sunday to all.

a small presentation as described in the registration mail is welcome, it is not a mandatory formality but serves to get to know one another a little better.

Welcome anyway. :smile: