Jonny123
Guest
hello to all, so I would have two questions about thesis work
1)from matlab I imported text files related to sections of a wing profile, profile that I then created in sw with "curve attravarso points xyz"
the question is, how do I quote the profile from one extreme to another to know how long it is?
this because I have to put it in the test room of the wind tunnel created with gambit, test chamber that is smaller and therefore the profile should be scaled
2)as I said as the profile goes into the test room, I have to attach it to the wall, which is why I created a support cylinder. But now I have to join the cylinder on the scaled profile....how do you scale, and how do they join?
thank you very much to all
and I take the opportunity to wish you good holidays
1)from matlab I imported text files related to sections of a wing profile, profile that I then created in sw with "curve attravarso points xyz"
the question is, how do I quote the profile from one extreme to another to know how long it is?
this because I have to put it in the test room of the wind tunnel created with gambit, test chamber that is smaller and therefore the profile should be scaled
2)as I said as the profile goes into the test room, I have to attach it to the wall, which is why I created a support cylinder. But now I have to join the cylinder on the scaled profile....how do you scale, and how do they join?
thank you very much to all
and I take the opportunity to wish you good holidays