ramp entry on z increments

[CARSON]

Good morning.
I'm trying featurecam and I've already come across a trivial problem...
I am trying to empty a pocket for floors but having set an increment (2mm as you see below) in z the cam performs the entrance into ramp only on the first increment (in blue in the image) and then move to the next depths with a double arc (?????). .. however decidedly too small for a heavy inserts.
How do I make him repeat the entrance ramp for all past z?
thanks for suggestions! !

 

[Fabrizio Di Feo]

Hello carson
I think unfortunately are the limits of the calculation engine for the 3d routes, rather than tell you to play with the ramp parameters e.g. length and angle I don't know.. advice (when possible) to use 2.5d strategies that are more easily controllable.

Hi.