psx2
Guest
Hello everyone,
I should change the system so I'm looking a little in
♪
a company I know has powermill but recently had problems with the calculation/recognition of the residual crude,
in practice after a roughening they would carry out a finishing that took into account the residual crude so as to increase the number of passes or decrease the
side step to avoid breaking the tool!
Now I ask:
but the rough
is it not taken into account by the only strategies of roughing ?
and so this behaviour is normal?
Thank you.
I should change the system so I'm looking a little in
♪
a company I know has powermill but recently had problems with the calculation/recognition of the residual crude,
in practice after a roughening they would carry out a finishing that took into account the residual crude so as to increase the number of passes or decrease the
side step to avoid breaking the tool!
Now I ask:
but the rough
is it not taken into account by the only strategies of roughing ?
and so this behaviour is normal?
Thank you.