realize an irregular solid having different odds

[Pediglio]

Bye to all,
I ask you a little help for the realization of an irregular shape solid. Since they are still in the first arms with the 3d, I have some difficulties to realize these types of solids. I better explain: I should make a solid that leaves from a 0,00 quota and arrive at the altitude of +0.80 constantly.
in this regard place a couple of images to better understand than it is (the solid 3d was made with single lines and not in 3d).

nothing special but being of irregular shape creates me some problem.
in this case how to proceed to have the result in figure?

 

[Tristan]

you can use loft or extrude shape and cut it with slice

 

[Pediglio]

thank you for the answer tristan but, as I said, being at first weapons I have some difficulties that however your suggestions do not clarify completely.
I therefore attach the image with highlighted the vertices so that I can have a clearer suggestion.
View attachment 41904Could you kindly list step by step how to do both with the loft and the tip?
thanks for patience and good to make.:smile:

 

[prismacad]

use prizes and drags and extrudes in plain sight (even greater than 0.80), put yourself in front view and draws the side triangle then extrude it in order to intersect (you can go even beyond) the solid obtained from the extrusion in the plant, finally, uses the intersect command to obtain the solid deriving from the two volumes in common.

 

[GP.]

the thing seemed trivial to me, I posted a solution that I immediately removed as the upper face cannot belong to a plan.
try this way:

- Extrude base for 0.80
- conjuncts with two lines the vertices to maintain at odds 0.00 with those at 0.80
- loft on the two lines
- Draw the extruded solid with the surface option (the loft) keeping the bottom

 

[Pediglio]

the thing seemed trivial to me, I posted a solution that I immediately removed as the upper face cannot belong to a plan.
try this way:

- Extrude base for 0.80
- conjuncts with two lines the vertices to maintain at odds 0.00 with those at 0.80
- loft on the two lines
- Draw the extruded solid with the surface option (the loft) keeping the bottom

center!!! :finger:
thanks gp for the suggestion revealed :smile:
I also thank those who spent time answering me.
thanks to everyone and to the next!

 

[GP.]

Please:

clearly you can do even on the contrary, or run the loft using the line that connects the vertices to 0.00 and that at altitude 0.80

 

[Pediglio]

Yes, of course: