reference plans

[Matteo]

Good morning, I apologize if the theme is banal or if already treated (I tried to look for).

I am beginning to use solidedge and the most confusing thing is the use of the reference plans, in particular:

1. I can't find the command to insert a reference plan
2. I can't see part plans in the environment together

If I find the solution in the meantime, I'll ask you. Would someone more experienced give me any indication? Thank you!

 

[Be_on_edge]

Good morning, I apologize if the theme is banal or if already treated (I tried to look for).

I am beginning to use solidedge and the most confusing thing is the use of the reference plans, in particular:

1. I can't find the command to insert a reference plan
2. I can't see part plans in the environment together

If I find the solution in the meantime, I'll ask you. Would someone more experienced give me any indication? Thank you!

Hi.

1: On the bottom right, in the status bar there is a box with "finder", write "piano" and press Enter.
2: Right-click on the part, "show\hide component..." menu, and select it in the "on" column of the line "reference plates".

*2: to show the reference plans temporarily while entering relationships you have a special button in the command tape bar. during use of "flash fit" to show the reference plans of a destination part you can press the r button and then click the part.

Hi.

 

[Matteo]

2: Right-click on the part, "show\hide component..." menu, and select it in the "on" column of the line "reference plates".

*2: to show the reference plans temporarily while entering relationships you have a special button in the command tape bar. during use of "flash fit" to show the reference plans of a destination part you can press the r button and then click the part.

Thank you! I knew how much I looked for the command in point 2* !

 

[Emanuela21]

Hi.

1: On the bottom right, in the status bar there is a box with "finder", write "piano" and press Enter.
2: Right-click on the part, "show\hide component..." menu, and select it in the "on" column of the line "reference plates".

*2: to show the reference plans temporarily while entering relationships you have a special button in the command tape bar. during use of "flash fit" to show the reference plans of a destination part you can press the r button and then click the part.

Hi.

Grazieeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeoooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooooo