franci.andre
Guest
Hello.
I'm an engineering student and I'm new here in the forum.
I'm doing a linear dynamic analysis of a prefabricated shed with straus7. I executed:
1.natural frequency
2.spectral response
3.linear static with the eight different combinations.
I have a problem when I go to open the results of the linear static at point 3, as when I try to change the combination, this error "floating point division by zero" appears to me.
Could someone help me? I also searched on the internet, but I can't solve it.
Thank you so much!
I'm an engineering student and I'm new here in the forum.
I'm doing a linear dynamic analysis of a prefabricated shed with straus7. I executed:
1.natural frequency
2.spectral response
3.linear static with the eight different combinations.
I have a problem when I go to open the results of the linear static at point 3, as when I try to change the combination, this error "floating point division by zero" appears to me.
Could someone help me? I also searched on the internet, but I can't solve it.
Thank you so much!