retinal display

[paga92]

Hello everyone! I have two questions to ask you.
1. I wondered if there is a way with archicad 17 to display two different retinals of the same wall.
I explain, I want to see a retino when I see the plant and a retino b when I look at the section of the same wall.


2. always regarding the retini, if I do a section according to one direction, for example the x direction, there is a way to make sure that in the direction y the retino of the section is different? for example the loft if I dissect it in x and y.

I've lost a lot of time on things, but I haven't found a solution. especially the second I don't think we can do it. but archicad already amazed me, so you never know!

if you also know different ways and/or better tell yourself as well. the important is the result!!! thankseeee ))

 

[eux]

I think there's a solution, but it's not worth a single item.
So... let's clear
archicad asks from the wall/solar/ecc settings the net you want to use for the section. then you tell him that your dissected wall must have a retino a.
he when sections in plant or section, displays the cut parts with retino a.
What could you do? .
when you do a section, from the section settings, you can say "for all you cut use the retino b (e.g.)". then that section will stick to the retino chosen by the wall settings and will use another retino, but - attention - for all the cut objects - indistinctly if walls, floors, etc...
If this aspect does not interest you, you can simply make 2/3/4/n sections all identical, but each with set a different cutting net. In this way, for example, the section displays the cut parts with a solid net, section b, which cuts identically in the same point, displays the cut parts with the concrete net etc...

I hope I've been helpful. In fact, it is a good question.