POllO2183
Guest
Good morning to all
I would like to update the standard designs with a change, I would like the surface finishes to be smaller.
The following procedure is therefore adopted:
options
document property
Notes
surface finishes
imposed the desired value in "text"
standard design
save in the external file
at the opening of a new file obviously load the file just saved (properties/properties of the drawing document/standard)
but nothing, the value always remains the one set previously.
I had already done this in the past to create my iso_modified and had never given me problems.
I therefore tried to make a change on the unit of measurement, to see if the problem depended on the surface finishes, but nothing yet. always stays with my old iso_modified.
Where am I wrong?
thanks for the help
I would like to update the standard designs with a change, I would like the surface finishes to be smaller.
The following procedure is therefore adopted:
options
document property
Notes
surface finishes
imposed the desired value in "text"
standard design
save in the external file
at the opening of a new file obviously load the file just saved (properties/properties of the drawing document/standard)
but nothing, the value always remains the one set previously.
I had already done this in the past to create my iso_modified and had never given me problems.
I therefore tried to make a change on the unit of measurement, to see if the problem depended on the surface finishes, but nothing yet. always stays with my old iso_modified.
Where am I wrong?
thanks for the help