screw without end

[solid3d]

hello could someone tell me how to build an endless screw of ø22 to 2 principles?
Thank you.

 

[marcof]

hello could someone tell me how to build an endless screw of ø22 to 2 principles?
Thank you.

near in the forum under the heading "helical waste". There's an advance to figure out how to make all the screws in the universe. to make it to two principles make a repetition of the first along the axis of a distance equal to half the step.

p.s. even if you had done the search for "unending lives" you would have found what you needed, only that the "search" and google key seems to no longer use them and you prefer to wait for the answer from someone who finds the same information you needed.

 

[re_solidworks]

before reading that discussion prepared convenient with the m&m's package because it will be long and difficult to deal with. ....

 

[Fulvio Romano]

before reading that discussion prepared convenient with the m&m's package because it will be long and difficult to deal with. ....

better m&m's than popcorn, because you'll need sugar. . .

 

[solid3d]

near in the forum under the heading "helical waste". There's an advance to figure out how to make all the screws in the universe. to make it to two principles make a repetition of the first along the axis of a distance equal to half the step.

p.s. even if you had done the search for "unending lives" you would have found what you needed, only that the "search" and google key seems to no longer use them and you prefer to wait for the answer from someone who finds the same information you needed.

I searched but found only that conical cmq I like google :smile:
and I will look for what you said, I have prepared both popconrs and m&m's, thanks to all:finger:

 

[marcof]

I searched but found only that conical cmq I like google :smile:
and I will look for what you said, I have prepared both popconrs and m&m's, thanks to all

Well, come on, if you found that, just make it cylindrical and add the other principle, and then it's the "principle" that counts...:finger:
Or do you want it just like the one you need to model?

p.s. if you go around the discussion about the helical excavation you will scratch the m&m, which you will need energy, while if you want to make us participate, we can enjoy the show with popcorn, beer and "free fruit. . " [cit.] :tongue:

 

[sampom]

I searched but found only that conical cmq I like google :smile:
and I will look for what you said, I have prepared both popconrs and m&m's, thanks to all:finger:

to "use the search button" meant the function of research here of the forum (top the page, in the menu bar). .
google was another resource, but here you enter the specific:biggrin:

greetings
Marco:smile:

 

[SolidUser]

hello could someone tell me how to build an endless screw of ø22 to 2 principles?
Thank you.

Make an extrusion of a circle.
Take a look here.use the sweep command with merge result 2 times changing the parameters of the step/rotation and as profile the profile of the screw.
If you twist, there is an option that says you keep the profile aligned and at this point select the cylindrical face.
when using the Solid Sweep command, press f1 and read the command a bit.

 

[solid3d]

Make an extrusion of a circle.
Take a look here.use the sweep command with merge result 2 times changing the parameters of the step/rotation and as profile the profile of the screw.
If you twist, there is an option that says you keep the profile aligned and at this point select the cylindrical face.
when using the Solid Sweep command, press f1 and read the command a bit.

Thanks for the advice I managed. :finger: