select more than one reference

[-Cesco-]

hello to all; Today the question is:
how do you select more than one reference after selecting the sketch plan?
that I need to make a rib of reinforcement

 

[tartufon80]

Bye!

Usually in these tutorials you will find a lot of information.
http://www.ptc.com/wcms/files/35805/en/35805en_file1.pdf

 

[-Cesco-]

Thank you so much!! I am already following a proe tutorial but I arrived at a point where they select a plan for the sketch and then three reports.... but with creo 1.0 I can select the plan and a reference!
and nn know how to select the other two....because with creo they give me the chance to put only one reference. ...

 

[tartufon80]

if on your profile write to use wf3, I link you to the wf3 tutorial. If you are looking for help, you will find how to view the additional references you need.

 

[-Cesco-]

You're right I've only noticed now.... I'm sorry...help you mean online driving? ?

 

[calacc]

Yes, the help is the online guide! However it is enough that when you are in sketcher press dx key, references, and you put all the ones you need to draw!

 

[-Cesco-]

I thank you but... in the sketcher screen... we will press the right button but nn me nothing...

 

[calacc]

try to hold it down a little more, it should open the window.. .

 

[-Cesco-]

found... top right... my mother....proe was more intuitive...thanks cmq guys

 

[-Cesco-]

large...beholding slightly pressed opens....alternatively on the top left! ! !
Thank you.