pietro2014
Guest
Bye to all,
I have read on old places that since 2011 there were problems regarding the distinction of the scanned and/or cut frames, as the lengths shown in the separate referred to the support unit .
Could any of you help me solve this problem with the inv2020 version?
I read from old posts that you could set the distinction indicating to refer to the length b.l, but I did not understand how you do it.
Thank you.
I have read on old places that since 2011 there were problems regarding the distinction of the scanned and/or cut frames, as the lengths shown in the separate referred to the support unit .
Could any of you help me solve this problem with the inv2020 version?
I read from old posts that you could set the distinction indicating to refer to the length b.l, but I did not understand how you do it.
Thank you.