sform analysis

[TECNOMODEL]

I planted myself in a banality but so much it is

if I activate a deform analysis then how do I return to normal display and continue working?

 

[gymbg]

I'm sorry it's the sform analysis? I use the deformed command because I almost always work with solid conicals on different sides and use it precisely to give the conicacy....

 

[TECNOMODEL]

in the analysis environment allows you to evaluate the sform of a solid.
I use it to verify that there are no subframes that prevent the release of the piece from the mold.

Anyway I found how to do, yesterday I was really fused

 

[Polymar]

apart from the sform speech in inspection->draft, I find inexplicable as a medium-high sw plated nothing less autodesk proposing a Moldova design module and at the same time does not allow to distort a surface. Perhaps it is the only one that still has this limitation despite on the official forum many users have complained already for a long time, but unfortunately autodesk "do not want to hear".