sgros-fin nerve shaped on the bottom

[monster]

Good morning.

I want to know if there is a command that allows me to peel nerves and finish them by following the gait of the bottom surface
then avoid the weaving in z with the roughing and then with the usual spiral finishingq to clean the bottom!

I don't know but you guys are captains??

 

[Dylan]

therefore.
Didn't they ever tell you that prosecco is not gas water?

nerve. I'll be fine. post the file we try to gabolate a solution!

dylan

 

[monster]

therefore.
Didn't they ever tell you that prosecco is not gas water?

:biggrin::biggrin: ehhhh but I come to visit you with family do you know what bomb we throw up?? :biggrin:

I'll send you by e-mail tonight.


ah for the friendly friends of toptron come forward

 

[cimaguy]

...return along the contour

(previous tool very large ).

...the prosecco is good but the cabernet, guys... .

Hi.

 

[Dylan]

...the prosecco is good but the cabernet, guys... .

Hi.

- Yeah. a bonarda ch mussa a little? So? Is it better than cabernet and prosecco? ?

but then it's useless to make the refined.. We'll go ahead and go on to ronco and tavern. .
The work here is an endangered thing. .

excellent idea of recovery. even if not optimal. Maybe the package has something to do.. but you have to know him well. .

dylan

 

[cimaguy]

I know it's better, but you know, my motto is, "less internet."

and more cabernet!"

However, doing the serious, the resumption along the contour I found that it works in such cases; it should perhaps extend here and there of the surfaces
to ensure that the route is well, but in principle
You get there.
If we want to be "surfaces" you can also use morph .

Hi.

 

[Dylan]

If we want to be "surfaces" you can also use morph .

Hi.

monster listens to the old man here.. use it again. .
In case you bought a new welding machine, try the adv!

dylan

 

[monster]

ohhh I send you the material via e-mail so much to account what it is about

take the case of recovery is fine until you use a spherical cutter
but with a flat cutter diameter 1 ...you want to retake the piece

I the multijet package tdi advance 4x4 I don't know how to use ...it sounds a little light and little performing. . It will be a matter of tastes

 

[UNKNOW]

try to go to a free cam course.
the hot line service in this case you need little.

I guarantee that there are new features in 9.0 specific for this processing.
ps: although I do not use it very much, I rediscovered excellent features.

 

[monster]

I guarantee that there are new features in 9.0 specific for this processing.

It doesn't matter.

 

[LuisVito]

It doesn't matter.

Hello monster

I've done it! :finger:
cmq sends the file also to me that these issues happen to me often at work.

Has anyone ever tried el turbiolino? .