simulated creo - mech

[F_Ingrasciotta]

Good morning.
I ask users of the forum if they are aware of a method to view the mesh on simulated creo after they have generated it.

Thank you.

 

[Prof.]

see when you generate it with autogem or on the results by activating the display of the elements.

 

[F_Ingrasciotta]

see when you generate it with autogem or on the results by activating the display of the elements.

Thanks for the answer. ok therefore it is as I believed (unfortunately). display after generation with autogem unfortunately is limited to summary screen after generation.

to tell us if you want to see mesh to waste time and analyze it after it is generated (because maybe I thought a point is critical) I must necessarily generate it again to see it.

sin.

 

[mastraa]

Hi.

you do not need to generate it again, if you saved it he simply reloads and displays it (if you did not make changes) when you click on autogem.

careful then that I create uses the p-method and not the h-method as the normal meshatori-solutors, unless you use the non-adactive single-pass already makes alone an infiction in critical points.


Andrea