simulationxpress not supported together. . .

[papafoxtrot]

Good evening to all,
I apologize if the subject has already been dealt with, I have not been able to find information about it; In practice my problem is this: starting simulationxpress in solidworks 2010 within a set, this warning appears to me.

Now I think that if simulationxpress wasn't supported in the mode together, there wouldn't be a command, would it? ?
Do you have any idea how I get this notice? Is that normal?

I use the student version (premium) 2010.

 

[re_solidworks]

if you have a premium you don't have to use simulationxpress because it only supports the parts. in the premium there is simulation (to be activated in added tools) to manage level analysis higher than the xpress.

 

[papafoxtrot]

Thank you so much!
Therefore it is not a problem due to some sorting, but precisely to the type of license, which however allows me to use simulation. Yes, the alternative I thought was to move on to that, but since with solidworks I just started, I had some sort of reverential fear of simulation

very kind and fast! now I go hunting simulation

 

[papafoxtrot]

In fact, it was enough to have some courage... simulation is not complicated until you use quite standard settings such as rigid constraints.
thanks for the tip on the activation of the simulation.