slowness and block problems with autocad 2014 on windows 7

[sciannaro]

Hello, guys.

I am new and if I have wrong section I ask in advance vein (the time to understand a little all the operation) . I have already read other discussions in the same forum but all different from my case. I ask you experts in the field to help me solve this problem. are a possessor of a quadcore sony i7-2630qm, 8gb ram, graphics card nvidia geforce gt 540m from 1 gb and a hard disk from 7200 rpm. operating system windows 7 home edition.
I come to this point: I installed autocad 2014 though I have problems in drawing, i.e. it freezes often and willingly, the mouse goes to snaps, every time I do a command tick the word doesn't answer up and then get out after 5 seconds (and in the meantime it's all stuck)... draw is impossible. Also known that since I installed autocad also the office 2010 that I installed makes certain slowing jokes quite noticeable.

I don't say I have a super computer, but I don't think it's so scary to get these disappointing performance (think I bought it to turn right autocad...). What can that be? ?
Discard me your opinion and I will do all the evidence!
I thank all in advance and hope that this will be the beginning of a good partnership

 

[PlannerRoad]

...also known since I installed autocad the Office 2010 that I installed makes certain slowing jokes quite noticeable. ...

safe at this point does not depend on any other active process on the pc?

 

[sciannaro]

What? I have no idea sincerely...

 

[PlannerRoad]

example antivirus, firewall, various programs that work in the background.

 

[sciannaro]

regarding the use eset nod32 antivirus and the firewall is factory set, I never touched it.
I also have the spybot. All of this because at first I thought there was something at the malware level that didn't go or some viruses, but it turns out everything ok... can it be that some autocad files go into conflict with someone from the office slowing both? if yes, what could be? I come to this conclusion because the problem is only with these two programs! the rest goes fast and smooth! even the photoshop goes a bomb!!!