solid edge: very slow together

[Davis]

I press that I am not very expert on solid edge; I said this, I have a very large axieme (about a hundred components) and for a few weeks I find myself unable to work because of the slowness of the program.
and example if I have to add a part and hook it to the rest of the drawing, only by clicking on move part, I get out the hourglass and the program plant.
Is there a possibility, for example, to load the parts with a light weight, or is there any option that I could control to make a bit of use of the program?
Thank you.

 

[cacciatorino]

I press that I am not very expert on solid edge; I said this, I have a very large axieme (about a hundred components) and for a few weeks I find myself unable to work because of the slowness of the program.
and example if I have to add a part and hook it to the rest of the drawing, only by clicking on move part, I get out the hourglass and the program plant.
Is there a possibility, for example, to load the parts with a light weight, or is there any option that I could control to make a bit of use of the program?
Thank you.

to load the parts light weight, look at the attached image, but it should be the default behavior.

for the problem that signals, make sure you don't have any constraints in conflict, and then I recommend you work with sub-assistances (i.e., lumps to be inserted in your assembly) so the management is very advantageous.