solve problems with pro-e

[blasco]

Hello, everyone. I use the pro engineer 3 program. I was looking for some exercise to do, even something more complex. I have always worked on autocad and for a couple of months I have passed to 3d. I would like some extra to help us a little bit, the program and fantastic but a little rigid here why with some evidence I could solve some grain. thanks to all

 

[maxopus]

to begin, did you try with the internal exercise of the program?
found in the following pdf file.

c:\dir_install_proe\html\italian\proe\helpsystop\siteset\gsguide.pdf

 

[blasco]

Sorry, but I can't find her. I have no folder with this name!!!

 

[maxopus]

It's impossible.

try searching for the gsguide.pdf file without indicating the directory

 

[blasco]

looking for the gsguide.pdf file I found the document in question. now to find perhaps some exercises on sweep functions, blend, etc?? ?

thank you very much maxopus for the help, very prepared... .

 

[Joe37]

go to the ptc site exactly on this page http://www.ptc.com/products/tutorials/wf4/localized/it/toc/index.htmhere are exercises on pro/e

 

[blasco]

Thank you very much!! !