spessore surface

[SATURNO07]

Hello everyone.. I have a problem, especially I have to give thickness to a surface in iges a little complex.. .spessore of 1.3, only that with the command "surfaces with thickness" it gives me error... are there other methods or other programs in order to make a thickness to a surface??? ? ?

thank you very much... if you want I can also send the surface by email.... help meiiiii:d

 

[alpole]

You could, as an alternative, make a surface offset or more properly,
from what seems to me to understand, of polysurface and then create surfaces
of closure in the edges, combine everything and solidify-
to the

 

[SATURNO07]

If I send you the piece, can you do it? Leave me the mail in pm

 

[SATURNO07]

I'm wrong even if I do the offset... :

 

[alpole]

If the data is imported, as I understand,
test with the command separates -gsd to fragment the
polysuperfic, then with the union-gsd command tries to
combine the various patches to reform the polysurface, if you can't,
test with the compose command, placing as condition
continuity of tangency;
in any case post your file, compatipibly with my loads
I'll see what I can do.
to the

 

[SATURNO07]

I tried, but it's not right. :

allego il file igs

 

[alpole]

this is the typical case of a "bad" construction of a polysurface
that, then prejudices a proper continuation, using
surface thickening feature or alternative to offset
polysuperficial
the topology of polysurf in some points that mark you in
images are bad, so the program is impossible
to return what we ask him
combining the various surfaces, even partially correcting them,
and launching the surf thickening command also for distances
minimum (mm 1,00 or lower values) the program from various
error messages and fails to solidify thickening
required-
launching the command offest in gsd and isolating some surfaces
we will get a missing incomplete polysurf of different patches
and in this case also with interecanti patches -
the same thing happens with variable offset always in gsd
What is different, but far from the result we expect, is done using
simplified command offeset, always in gsd environment, we will be returned
single surface approximated with a non-lower degree
to 1 mm which, in some cases, can be used, without
which, successive cutting operations must be carried out
to the edges, of cracking other closing surfaces between the polysurf
original and the offset surf obtained, before being able to combine everything
and solidify-
you could also attempt to arbitrarily close the polysurf
solidifying everything and at this point creating by
shell in environment part the required emptying of mm 1....but
also in this case the programmma detects the manifold edges
So he doesn't do the operation--
In essence, I explained to you
five possibilities catia makes you available to achieve the purpose
- polysurfing thickening - part
-offset -gsd
-offset simplified -gsd
-offset variable -gsd
- consolidation and emptying - parting
as long as the polysuf is topologically correct, preferably with
tangency surfaces and consistent closures -
It is not our case, so the advice is to review
the basic surfaces, trying to create a correct polysurface-
to the
ps- attached the file with the realization of the union and the surf of offset
simplified -

 

[SATURNO07]

ok thank you, I solved otherwise... you can close

 

[alpole]

I would like to know how you proceeded and with which
Did you do that?
Thank you.
to the