sphere

[fast975]

hello to all and good work. . .
I am working with the prg md3 (thinkdesign)
I'm processing a sphere and I have problems creating on
surface of the pockets obtained from spline.
the fact is that not succeeding in having the curved plan as the ball the command does not work, tells me that the curves do not lie on the working plane.
Can someone help me?? ? ? ?
Thank you...

 

[Sasso SP]

hello to all and good work. . .
I am working with the prg md3 (thinkdesign)
I'm processing a sphere and I have problems creating on
surface of the pockets obtained from spline.
the fact is that not succeeding in having the curved plan as the ball the command does not work, tells me that the curves do not lie on the working plane.
Can someone help me?? ? ? ?
Thank you...

Hi.
but the splines are on the surface of the ball??? you know me!
However if you can project the spline on a floor (probably perpendicular to the walls of your pocket) and make your cut (if that's enough).
If the spline on the ball you can use the controls for surfaces... .
if you can post some pictures! !

 

[fast975]

Thanks to the help... I didn't think about it... everything solved.
good work:finger: