spherical joint

[PabloPicasso]

you could give me some ideas on what constraints to apply to create a "ball joint" like this:

in practice the pin with the spherical bushing must move to 360 degrees inside the housing.

with the tangency bond I can make it rotate, but it comes out from the seat.

 

[MauroM]

put a point in the center of the ball and a point in the center of the seat, and then vicolo coincidence. I didn't try, but it should work.

 

[Tarkus]

put a point in the center of the ball and a point in the center of the seat, and then vicolo coincidence. I didn't try, but it should work.

It works, it works... .

 

[PabloPicasso]

It works, thank you. I didn't think about it. You can also bind the point with a plan.

 

[diegus]

In addition with 2011 it is possible to add constraints with max and minimum value to limit the race of the rotula according to the specifications of the manufacturer.

small place with example