spy design spline modeling 2d

[nicola toppano]

hello to everyone, I would like to know if someone more experienced than me can help me solve a problemuccio:wink:
I have made a design consisting of multiple curves made with spline modalities, but now for other needs of processing I would like to spy on them to collect all the joints.... is it a feasible thing?
I don't know if I'm well explained, I hope so.

use autocad 2011
thanks for the attention:finger:

 

[gianlucap]

hello to everyone, I would like to know if someone more experienced than me can help me solve a problemuccio:wink:
I have made a design consisting of multiple curves made with spline modalities, but now for other needs of processing I would like to spy on them to collect all the joints.... is it a feasible thing?
I don't know if I'm well explained, I hope so.

use autocad 2011
thanks for the attention:finger:

I try to interpret your request. If you like spying you want to make your spline all curve a straight, click on the spline join the grips by only remaining the first spline start and the last spline end, put a vertical or horizontal construction line depending on how you need it and then align the spline grips on the construction line.

 

[nicola toppano]

Hello, thank you for the answer! But I didn't make myself understand what I'd like to do, and so I try to explain myself better:
when I draw or recalculate a figure with the spline, sometimes I happen to have to do a lot of points to follow all the curves. By cutting lasers on these files I happen that on the piece you see the joints between one spline and another...for this if it were possible I would like to make you (if possible) regenerate the design as I had done a single spline line!
Is it clearer what I mean?

 

[gianlucap]

What if you create a block? try to make a test, draw a spline with so many curves, then go on drawing, block, create, give it the name to your block and you appear as a unique form

 

[xxfast]

I did a test, trying to interpret your needs.
if you use the command create region you should get a unique object by eliminating all igrip of the spiline.
Look at the figures below...View attachment 22777
View attachment 22778only the connection points between one spiline and the other will remain.

 

[nicola toppano]

I'd say I did, I'll make a cut test for sure!
thanks to both for the advice you gave me...... I would not have arrived:finger:
See you soon!

 

[xxfast]

I'd say I did, I'll make a cut test for sure!
thanks to both for the advice you gave me...... I would not have arrived:finger:
See you soon!

Let us know how it went...:smile:

 

[nicola toppano]

I still did not try to cut the piece......who had to judge the aesthetics was not so fascinated:frown:
and I have so much work....... .
Now I have to change everything, however as soon as I try to cut you I will let you know! !