straps

[Christian76]

Good evening
a courtesy,
It's not my job, so forgive me for any definition mistakes. . .
I have to try to design with a friend an application where I have to mount straps and pulleys t2.5 (dentate)
two questions, the first if you know where I can recover the 3d of the pulleys and any bearings...(centre contents? I look at us tonight, I usually never use it for work)
The other thing I was interested in is if I'm inv, it simulates the movement with the belt... but I think I'm not...

Thanks

 

[alessandroM]

Perhaps you can try to simulate the movement of the pulleys and belts by binding the contact zone between a tooth and its correspondent on the belt, and you should do it both for the drive pulley and for that conduct, however you wouldn't be able to make him make a complete movement, but it would stop at the moment when the teeth tend to get away. But I don't know how to give it, you should try a little... I hope I've been useful to you!

 

[Tarkus]

Good evening
a courtesy,
...................................................................
The other thing I was interested in is if I'm inv, it simulates the movement with the belt... but I think I'm not...

Thanks

bearings on cc
dentate pulleys click on autodesk exchange apps, that kind of "x" next to "?" on the top right, and see if you find something on the site of some manufacturer.

motion simulation: i.e. see the teeth of your sludge moving? :36_6_4:
If you want to be mad you can try, but you won't get a spider out of the hole....:36_1_14:

 

[pompeo79]

find everything (with areas also dedicated to designing loads/attrites/etc) in the design area acccelerator (environment together > design)

you can do both things by yourself risky (insertion parts and design) and animation of the belt, but the roads are different, the procedure for the second road is in fact quite laborious and fine to itself ( animation/presentation, and method valid to animate conveyor belts, chains, straps, etc.).

if you are aware of the animation of the pulleys (but not of the belt, which will be steady), you can do everything quietly from the accelerator design and its design areas.

 

[Tarkus]

true, on design accelerator there's everything, (there are not the pulleys htd ).:finger:
I didn't mention it because:
-The pulleys are without cod,
-The straps are without teeth.
therefore seen the demand for a realistic animation of the movement, from me seemed useless..