style

[DANI-3D]

Hello everyone

problem
In the flat state of a sheet, I have to insert some dotted lines that will serve me to make cuts drawn during laser cutting.

solution solution
on the surface of the flat plate I created a sketch and taking as reference some folds I have inserted lines and I gave it as a solidfont line style, which is what approaches more to the type of restraint I want to get. But I would have the need to manage the spacing of the dash, a little like it did, centuries ago, with autocad with the ltscale command, remember? is it possible to obtain a similar result?

Thank you.

 

[BFausto]

Hi, I'm trying to answer you.

for the purpose try to look here:
https://www.ptcusercommunity.com/message/263481#263481https://www.ptcusercommunity.com/thread/37874on this, I go to memory, when I nested more than a century ago for laser cutting I used a different color of line to perform an alternative process to the cutting (e.g. tracking of the folds) that the laser cutting prog. interpreted appropriately.

 

[DANI-3D]

Hi.

I don't work, line_style_length dashfont 0.400000 doesn't take it between the options ne between the drawing options, but is it possible also with wf5 ?

 

[BFausto]

ciao.
https://www.ptcusercommunity.com/thread/37874looks like wf5.

 

[DANI-3D]

ciao.
https://www.ptcusercommunity.com/thread/37874looks like wf5.

Okay, but I can't figure out where to put those instructions...

 

[BFausto]

Hi.

Unfortunately, neither do I (cree 3).

in creo3 in 2d I tried: sketch->formato->Manage line characters.