suspect939

[mastmotion]

hello to all

on some files coming from nx3 and opened in nx5 I get out this damn error suspect939

attached there is the image of the error... .

you will say... check all the splines.... I will answer the splines are 20000 azz

kindly, help me eliminate this error.

denghiu

 

[IPdesign]

I guess you already did a refile, a part cleanup.
and maybe even searched for the feature tree with an allert icon?

 

[mastmotion]

unfortunately I don't have features are just curved, I tried to check without the timestamp in the feature tree if the spline had an allert, but nada.

 

[ceschi1959]

Try to take a look here:
http://www.eng-tips.com/viewthread.cfm?qid=214694&page=79Then tell me if you needed it.

Hi.

 

[mastmotion]

Try to take a look here:
http://www.eng-tips.com/viewthread.cfm?qid=214694&page=79Then tell me if you needed it.

Hi.

Unfortunately I have already done research on google... .

the fact is that with the selection with the filter of the name you do not select me anything and the thing even more breaks.... is that besides having the spline in the 3d, I also have a 2d directly under the same file that contains alternate spline, so it is impossible to find stalk of spline.

 

[ceschi1959]

try to 'export' drafting by passing in master model, then delete 2d from the original and so see if the problem persists.

 

[mastmotion]

try to 'export' drafting by passing in master model, then delete 2d from the original and so see if the problem persists.

How do you delete the 2d?!?!?!? And then the odds who puts me back????? Aah!
you know when you expose the 2d where the views are associated with other files, the odds not if you bring them, so I should requote a 4a0 or no thanks I prefer the error :°d

then I found the component that bothers me (which unfortunately is not my intention, but of the customer, therefore not editable), but not the spline (extracted associately on the 2d).... so I would need to understand if there is a command that finds me that spline then rebuild it to the maximum.

 

[ceschi1959]

with the export part command create a new part where the starting file becomes a component of the arrival file and so works in master model. in the new file you will find the drafting (full of all odds).
the suggestion was intended to 'split' the problem and see if it depended on modeling or drafting. more simply you could have done a backup copy of your file, delete drafting, save and reopen the file to see if the problem depended on the table.
:smile:

 

[procatug]

the 9 suspect39 occurs when there is an extract edge in the 2d and is due to the presence of curves with a number of poles greater than the degree of the curve itself. the error is already present in nx3 and, of course, is resumed by nx5. to identify the splines you must proceed as follows:

1) object information/ attribute filters;
2) in the next dialog set strings as attribute type and suspect939 in the title field;
3) after ok, nx will highlight the curves with the suspect;
4) go to the properties of the curves highlighted and eliminate the attribute;
5) go to edit curves of the highlighted curves and increase the degree;
6) perform a cleanup part
7) saved
at the reopening you will no longer have the message.

 

[IPdesign]

great procatug.
all very clear, now we wait for mastmotion to try the procedure and tell us if it has got the outcome hoped