sw2010 elliptical and bent notes

[CORRADINI]

Hello to all boys
I have to draw an elliptical form "full" with axes data and bases... I don't remember how to do it with sworks2010

Does anyone have any suggestions? ? ? ?

other question-->I can't see the bending lines when amounting a flat repetition in the drawing sheet.... why??? ? Thank you.

 

[Mike1967]

Hello to all boys
I have to draw an elliptical form "full" with axes data and bases... I don't remember how to do it with sworks2010

Does anyone have any suggestions? ? ? ?

other question-->I can't see the bending lines when amounting a flat repetition in the drawing sheet.... why??? ? Thank you.

mhhh... copy paste.... less bad than you did, honey.
http://www.cad3d.it/forum1/showpost.php?p=181087&postcount=10:biggrin:

 

[sampom]

..and always two different topics in the same thread:

however;
sketch an ellipse (there is the special command) and extrude it.

verify that in options > document ownership > sheet (from the table) the voice appears show sheet bending notes and from the menu view view (always from the table) the voice is highlighted sketches.
if you continue not to see the folds there may be errors of modeling of the sheet.

then read the help, guide online and do the tutorials.
and read the forum regulation:biggrin:

greetings
Marco:smile: