sw'90 lamiera calandrata

[BIXIO]

is there a way to draw with the sheet module an object equal to half funnel, and then have the flat repetition?


I'm getting crazy.

in 3d simple do profile revolution, but for flat repetition for laser cutting?

Greetings

 

[re_solidworks]

solidworks '90 is a little obsolete. I think the first version was '95. You mean 2009?

However if you mean a cone medium is simple and you do it either by turning the solid into sheet metal with the command insert poegature. instead of the face you have to select a edge of the generator.

 

[re_solidworks]

here is an example.:finger:

 

[sampom]

here is an example.:finger:

I think I understand that the bixio friend also needs the "nase", just like a home funnel.
If this were to be done in a piece only of sheet metal would be a little impossible.. or do you have re_ solutions?

greetings
Mar

 

[re_solidworks]

I think I understand that the bixio friend also needs the "nase", just like a home funnel.
If this were to be done in a piece only of sheet metal would be a little impossible.. or do you have re_ solutions?

greetings
Mar

in this case you have to do it in two pieces or use an application for funnel.

You must make a fun! :hahahah:

Sorry about the joke, it's a difficult time and I've got to get a little dehydrated.