sweep variable section

[peppe068]

Hello, everyone.
I'm struggling with something that's taking me years of my life in no time.
I swear I read everything and more. It's simple, banal. but always when I see him do to others.
I have read this discussion and I have studied the subject in question for good:http://www.cad3d.it/forum1/showthread.php?t=14419&highlight=sweepmine is similar, but there is no way that he can do it. Could you take a look at him?
I look anxious.

 

[folle76]

as I pointed out there are 2 curves and a tangency line at the same point. In this way you can't build on it or a sweep or a blend. If you do so (even by little) that you don't happen this condition quietly pass all the surfaces. And then, if you want, you can get us a little connection.
This is my opinion. tomorrow you model correctly. At least as I would if I had to produce it!
Hello and 'night.

 

[folle76]

I coach you .neu and .prt (I have wf 5.0). if the intent is educational is fine. If it's to be produced, it's a little shit. I would build the surfaces in another way.

 

[peppe068]

I coach you .neu and .prt (I have wf 5.0). if the intent is educational is fine. If it's to be produced, it's a little shit. I would build the surfaces in another way.

first of all thanks for the straight, it was illuminating. I managed to get what I wanted!
will not have an elegant method to get the particular, but here is the result.
Thank you, I owe you.

 

[folle76]

pay me rent and we're good.

 

[fenice consulenze]

pay me rent and we're good.

Why don't I see an answer?? ? :biggrin:

 

[peppe068]

What do you say? I made accreditation for the first 6 months of 2010. Did you get him crazy? :wink: