symbol 'disvicted components' on imported assemblies

[Aleee45]

Good morning.
is it possible on creo 8, after importing a set through a step, see in the component tree the symbol, on all pieces, which indicates the freedom of movement of the piece?

I see all the pieces as if they were completely bound. But I'm not. to see it I have to open the "assembly" interface, save and close. this for every single piece.

Is there no way to do it on everyone automatically?

 

[freexf]

the purpose of an export in step format is to export only mathematics (geometria).
normal then what you meet.

 

[Aleee45]

the purpose of an export in step format is to export only mathematics (geometria).
normal then what you meet.

all the other cads I used had this option. No, it doesn't seem normal sincerely.

 

[solokite]

all the other cads I used had this option. No, it doesn't seem normal sincerely.

Have you tried to make selection all and make fixed?