tangent point ad surface

[leggera]

Good morning.

Is it possible to bind one part to another's surface?
In this way I could put a point in the center of the sleeve, in my case then bind it to the surface of the tube so that it always protruding for half.

It seems that the link between point and surface is not possible or perhaps wrong procedure I.

Thank you.

 

[DrBarde]

Good morning.

in 2020, I think, that the only possible link between a point and the surface of a component is coincidence.
In his case, I would recommend that you give the coincidence between the above point with the radius of the pipe as a distance, giving as reference the axis of the pipe.