thermo-structural analysis

[bdario]

Good evening.

I have a question about thermo-structural analysis. Therefore, after performing the thermal analysis amount my data in a structural analysis so as to detect deformations and efforts due to the thermal load. However, the thermal load and therefore the result in each node of thermal analysis, I must increase it of a factor of 1.5, how do I? is it possible to do it in nx? Since data transfer to structural analysis takes place by recalling the op2 file of the results of thermal analysis, I do not find how to do it.

thanks to all in advance

 

[ceschi1959]

Good evening.

I have a question about thermo-structural analysis. Therefore, after performing the thermal analysis amount my data in a structural analysis so as to detect deformations and efforts due to the thermal load. However, the thermal load and therefore the result in each node of thermal analysis, I must increase it of a factor of 1.5, how do I? is it possible to do it in nx? Since data transfer to structural analysis takes place by recalling the op2 file of the results of thermal analysis, I do not find how to do it.

thanks to all in advance

hi bdario,

I see that you ask very specific questions about equally specific topics.
I can't help you as I've never worked with the nx simulation module and I hope some other user can help you; I suggest you take a look at this site where maybe you can get answers.
http://community.plm.automation.siemens.com/t5/nx-student-forum/bd-p/nx-student-forum

ciao c.

 

[bdario]

Thank you very kind.

hi bdario,

I see that you ask very specific questions about equally specific topics.
I can't help you as I've never worked with the nx simulation module and I hope some other user can help you; I suggest you take a look at this site where maybe you can get answers.
http://community.plm.automation.siemens.com/t5/nx-student-forum/bd-p/nx-student-forum

ciao c.