thread tubes iso wrong.

[Tarkus]

already 'it was 2010 and on 2011 I was equal:
in the holes feature: thread tubes iso, e.g. 1/8 rightly says that it measures ø 9.728, and instead I plant a hole of ø 3.18, i.e. 1/8 inch.
same story for g 1/4: expected ø 13.157, result: ø 6.35 i.e. 1/4 inch.
and so on saying...
Is it a mistake that happens to me, or is it already known and maybe there's something to correct it?

 

[diegus]

I think it doesn't happen. If I make the hole from 1/8 I make the hole from 8,566

 

[Tarkus]

found why:
I have the document with options-> modeling-> hole , set to : pre-hole diameter.... .
It's the only trouble for now that I've encountered keeping it in this setting. . .

 

[Daniele_69]

do a verification, but I think it also changes the representation in the table (if you put more does not make the circle + arc indicating the threads).
Hi.

 

[Tarkus]

do a verification, but I think it also changes the representation in the table (if you put more does not make the circle + arc indicating the threads).
Hi.

Okay, thank you, I'll also do this. .