tilted floor problem

[bradipetto]

Hello everyone, I am new to the forum. I have a question, indeed, a problem with tilted floors. I am drawing a catwalk, which at a certain point descends of 1,20m and then goes back and meets the initial path. only that the plan is not "inclined" in a homogenous way because of a line that cuts the plan in half and that does not fit the design.
I'll attach the picture so you understand my problem.

Thanks for the attention, I'm starting to use revit now, it's fantastic! I will show you the final result!

 

[Alfredo Medina]

How are you doing this? like a ramp or as a floor with changed points?

 

[ocraM999]

This happens because you are wrong to build the catwalk in the tilted sections, you have to set the odds on the flex lines of the walkway. in other words the tilted catwalk must necessarily be rectangular (not trapetidal as in your case)
use the command 'add line of division'
marco